1967 Shelby GT 350
If patina tells a story, then this GT350 has quite the tale to share.
Latest updates
Feb 28, 2024
Come see several Classic Motorsports project cars at our first-ever Classic Motorsports Amelia Island Kickoff Presented by Sunoco–including our 1967 Shelby GT350.
Nov 2, 2023
We were excited about our GT350's next outing, but there was a lot we needed to fix first–in a very short amount of time.
Oct 26, 2023
Clutch going bad? Why just replace it when you could upgrade the transmission, too?
Feb 17, 2021
Our Shelby GT350 is one of our favorites, but how does it compare to a Sunbeam Tiger?
Oct 15, 2013
We modify our upper control arm mounting point for better suspension geometry.
Sep 18, 2013
Only minor issues hindered us on the Going to the Sun Rally.
Sep 11, 2013
We crossed the border to Canada and found a surprise along the way.
Sep 9, 2013
We installed a new pump while we were on a road trip with our Shelby GT350.
Sep 6, 2013
We drive the best tool for the job of roaming the dry and mountainous West Coast.
Sep 4, 2013
We enjoyed our trip, driving our Shelby on the West coast of this beautiful land.
Aug 30, 2013
Our Mercedes is down for an engine swap, so the Shelby is hitting the road.
Aug 28, 2013
We improve our Shelby's breathing.
Apr 18, 2013
The stock brakes just weren't up to task.
Feb 15, 2013
We take our Shelby to our test track to set a baseline.
Oct 28, 2012
Horsepower + burnouts = cooked clutch
Jun 20, 2012
Boys will be boys. We tune the engine, then abuse the clutch.
Jun 13, 2012
We keep blowing turn signal switches, but can't quite figure out why.
Jun 4, 2012
The Shelby makes some appearances and revisits the dyno.
May 21, 2012
The Shelby needed more stick.
Apr 19, 2012
The Shelby is on display in Charlotte this weekend.
Apr 10, 2012
We get our Shelby's air conditioning blowing cold to prepare for hot Florida summers.
Mar 28, 2012
We show off our Shelby at the Silver Springs Florida All-Ford Show in Ocala.
Mar 22, 2012
We tune our Shelby to resolve the engine's rich running condition.
Mar 16, 2012
We address a few niggling issues on our Shelby.
Mar 8, 2012
We start attacking our to-do list for our Shelby GT 350.
Mar 5, 2012
We add weathered-looking sponsor decals to our Shelby, giving birth to the Terlingua Terror.
Feb 29, 2012
Our Shelby hits the dyno before departing for the Texas 1000 rally.
Feb 13, 2012
After lots of blood, sweat and tears, our Shelby is ready for that first drive.
Feb 1, 2012
We set the Shelby's alignment for the right mix of comfort and performance.
Jan 31, 2012
Putting the nose back on our Shelby GT 350 project.
Jan 24, 2012
Restoring the interior panels on our Shelby Mustang.
Jan 20, 2012
Finishing the seat restoration on our 1967 Shelby GT 350.
Jan 19, 2012
Fitting the perfect headers and exhaust system for our Shelby GT 350.
Jan 17, 2012
The engine won't run without one.
Jan 13, 2012
Our Shelby Mustang can go and stop. What's left?
Jan 11, 2012
Armoring our Shelby against any cooling problems despite its extra 200 horsepower.
Jan 4, 2012
With the engine installed and the clutch in place, it was time to get the rest of the ancillary systems figured out.
Dec 28, 2011
We look for the best clutch setup for our Shelby GT 350.
Dec 7, 2011
Finding the right answers for our power steering and brake questions.
Dec 5, 2011
We refurbish our Shelby's a/c setup while retaining the factory-correct appearance.
Dec 2, 2011
Finding the right wheel-and-tire combination for our Shelby Mustang.
Nov 30, 2011
Just like the rest of our Shelby, the transmission needed attention.
Nov 28, 2011
Adding new brake lines and fixing our fuel delivery problems.
Nov 18, 2011
With the underside of our Shelby painted to MCA concours standards, it's time to bring it home for reassembly.
Nov 14, 2011
To make a rough old Mustang concours-correct underneath for Mustang Cub of America judging takes a lot of work.
Nov 10, 2011
It's time to fess up: This project was a lot more work than we thought it would be.
Oct 11, 2011
We perform more cleaning, welding and grinding underneath our Shelby's unibody.
Sep 23, 2011
We sandblast the engine compartment and work on the seats of our Shelby.
Sep 13, 2011
Undoing past sins on our survivor Shelby.
Sep 6, 2011
Cleaning with the power of steam and thinking about brakes.
Aug 31, 2011
Time to tackle the metalwork on our Shelby project.
Aug 26, 2011
The thrash continues: We nearly strip our Shelby's chassis in one day.
Aug 16, 2011
Our driveline teardown reveals good news.
Aug 11, 2011
We've barely begun work on our Shelby, and we're already behind schedule.
Aug 8, 2011
We begin a six-week thrash on our patina-rich Shelby.
VyRrXt23zlIMUvjz6dUfViAvSTItfyqEizPQUDQhaMteOFSofSEzWj53oVXPYUGw